Table of Contents

FOREWORD
1 General
  1.1 Scope
  1.2 Normative references
2 Technical data
  2.1 Units and symbols
  2.2 Definitions
  2.3 Preferred values
  2.4 Marking
3 Quality assessment procedures
  3.1 General
  3.2 Primary stage of manufacture
  3.3 Structurally similar inductors
  3.4 Qualification approval procedures
  3.5 Quality conformance inspection
  3.6 Alternative test methods
  3.7 Unchecked parameters
4 Test and measurement procedure
  4.1 General
  4.2 Standard atmospheric conditions
  4.3 Drying
  4.4 Visual examination and check of dimensions
  4.5 Insulation resistance
  4.6 Voltage proof
  4.7 Inductance
  4.8 Insertion loss
  4.9 Robustness of terminations
  4.10 Resistance to soldering heat
  4.11 Solderability (applicable only for terminations
       intended to be soldered)
  4.12 Rapid change of temperature
  4.13 Vibration
  4.14 Bump
  4.15 Shock
  4.16 Container sealing
  4.17 Climatic sequence
  4.18 Damp heat, steady state
  4.19 Temperature rise
  4.20 Endurance
  4.21 Passive flammability
  4.22 Active flammability
  4.23 Solvent resistance of marking
  4.24 Component solvent resistance
Annex A (normative) Interpretation of sampling plans and
        procedures as described in IEC 60410 for use within
        the IEC quality assessment system for electronic
        components (IECQ)
Annex B (normative) Rules for the preparation of detail
        specifications for capacitors and resistors for
        electronic equipment
Annex C (normative) Requirements for earth inductors

Abstract

Applicable to inductors designed for electromagnetic interference suppression intended for use within, or associated with, electronic or electrical equipment and machines.

General Product Information

Published
Document Type	Standard
Status	Current
Publisher	International Electrotechnical Committee
Pages
ISBN
Committee	TC 40