Table of Contents

FOREWORD
PREFACE
SECTION ONE - GENERAL, SUPPLEMENTARY DEFINITIONS AND
              CONDITIONS OF MEASUREMENT
1 Scope
2 Object
3 Supplementary terms and definitions
4 Standard test conditions
5 Supplementary test conditions
6 Characteristics of the measuring equipment
SECTION TWO - METHODS OF MEASUREMENT
7 Frequency error
8 Terminal radio-frequency power
9 Radiated radio-frequency power
10 Input power and overall efficiency
11 Inter-transmitter intermodulation
12 Modulation characteristic
13 Modulation sensitivity
14 Total distortion factor
15 Relative audio-frequency intermodulation product level
16 Compressor characteristics
17 Modulation limiting
18 Residual modulation (due to hum and noise)
19 Transmitter attach time
20 Transmitter performance under conditions deviating from
      standard test conditions
APPENDIX A - Recommended characteristics of the measuring
             equipment
APPENDIX B - Example of a main power lime impedance
             stabilization network

Abstract

Gives the definitions, the conditions and the methods of measurement used to ascertain the performance of transmitters and to make possible a meaningful comparison of the results of measurements made by different observers and on different equipment.

General Product Information

Published
Document Type	Standard
Status	Current
Publisher	International Electrotechnical Committee
Pages
ISBN
Committee	TC 12
Supersedes	IEC 489-2A : 1981