Table of Contents

FOREWORD
PREFACE
SECTION ONE - GENERAL, SUPPLEMENTARY DEFINITIONS AND
              CONDITIONS OF MEASUREMENT
Clause
1 Scope
2 Object
3 Supplementary terms and definitions
4 Standard test conditions
5 Supplementary test conditions
6 Characteristics of the measuring equipment
SECTION TWO - METHODS OF MEASUREMENT
7 Frequency error
8 Terminal radio-frequency power
9 Radiated radio-frequency power
10 Input power and overall efficiency
11 Inter-transmitter intermodulation
12 Modulation characteristic
13 Total distortion factor (of a sine-wave at audio
   frequencies)
14 Relative audio-frequency intermodulation product level
15 Automatic modulation control characteristic
16 Transmitter attack time
17 Transmitter performance under conditions deviating from
   standard test conditions
APPENDIX A - Recommended characteristics of the measuring
             equipment
APPENDIX B - Guide for the construction of a 30 m radiation
             test site for equipment emitting radio-frequency
             electromagnetic energy
APPENDIX C - Example of a mains power line impedance
             stabilization network
APPENDIX D - Guide for the construction of a 3 m radiation
             test site for measurements above 100 MHz of
             equipment emitting radiofrequency electromagnetic
             energy
APPENDIX E - Power measuring receiver

Abstract

Covers the definitions, the conditions and the methods of measurement used to ascertain the performance of transmitters having audio frequency bandwidths generally not exceeding 10kHz for the transmission of voice and other types of signals, using single sideband amplitude modulation with full, reduced or suppressed carrier. This standard is intended to be used in conjunction with Publication 489.1.

General Product Information

Published
Document Type	Standard
Status	Current
Publisher	International Electrotechnical Committee
Pages
ISBN
Committee	SC 12F