Table of Contents

1 Overview
  1.1 Scope
  1.2 Purpose
2 General requirements and definitions
  2.1 Mechanical
  2.2 Electrical
  2.3 Environmental
3 Recommended electrical test procedures for GPC and LPC
  3.1 Statement
  3.2 Reflection coefficient
  3.3 Connector repeatability
  3.4 Insertion loss and phase measurement
  3.5 Shielding effectiveness
  3.6 Direct-current contact resistance
4 Recommended mechanical test procedures for GPC and LPC
  4.1 Mechanical requirements specified
  4.2 Recommended mechanical test procedures
5 Connector summary table
  5.1 Introduction
  5.2 How to use this summary table
  5.3 Definitions
Annex A (informative) Inner conductor gap study
Annex B (informative) Inner conductor slotted contact study
Annex C (informative) Detail specifications for precision
        coaxial 14 mm conectors
Annex D (informative) Detail specifications for precision
        coaxial 7 mm connectors
Annex E (informative) Detail specifications for precision
        coaxial Type N conectors
Annex F (informative) Detail specifications for precision
        coaxial 3.5 mm conectors
Annex G (informative) Detail specifications for precision
        coaxial 2.92 mm conectors
Annex H (informative) Detail specifications for precision
        coaxial 2.4 mm conectors
Annex I (informative) Detail specifications for precision
        coaxial 1.85 mm conectors
Annex J (informative) Detail specifications for precision
        coaxial 1 mm conectors
Annex K (informative) Bibliography

Abstract

Describes coaxial connectors for precision electrical measurements to 110 GHz. The frequency range of the standard is increased from 65 GHz to 110 GHz since in the market exists a 1 mm connector with a rated upper minimum operating frequency of 110 GHz. The members of the subcommittee felt, in view of this, the scope of the project should be changed to incorporate this advantage.

General Product Information

Published
Document Type	Standard
Status	Current
Publisher	Institute of Electrical & Electronics Engineers
Pages
ISBN