M00023019
New product
STANDARD FOR MECHANICAL REAR PLUG-IN UNITS SPECIFICATIONS FOR MICROCOMPUTERS USING IEEE 1101.1 AND IEEE 1101.10 EQUIPMENT PRACTICE
Institute of Electrical & Electronics Engineers
In stock
Warning: Last items in stock!
Availability date: 10/29/2021
1 Overview
1.1 Scope
1.2 Purpose
2 References
3 Terminology
3.1 Abbreviations
3.2 Special word usage
4 General arrangement
5 Relationships of front and rear plug-in units
5.1 The in-line configuration, non-EMC and EMC
6 Rear mounted plug-in unit printed board (Euroboard)
sizes
6.1 Board height
6.2 Board depth
6.3 Rear mounted plug-in unit inspection dimensions
7 Connector orientation, pin labeling, and printed board
component view
8 Subrack rear attachment plane
9 Rear backplane mounted plug-in unit fixed connector
relationship
10 Rear subrack connector (backplane mounted) shroud
orientation
10.1 Connector shroud orientation
11 Backplane bow and support
12 Connector performance
13 Connector alignment
14 Rear mounted plug-in unit cooling consideration
15 Front and rear plug-in unit front panel protective ground
15.1 Mechanical design
15.2 Requirement
15.3 Resistance
15.4 Minimum galvanic compatibility and contact
operations
15.5 Pass criteria
Annex A (normative) Inspection Dimensions for Subracks and
Associated Plug-in Units in Accordance with
IEEE 1101.1,IEEE 1101.10 and IEEE Draft P1101.11
Using the IEC 61076-4-101 Connector Series
Annex B (informative) Bibliography
Applicable in all fields of electronics where equipment and installations are required to conform to the 482.6 mm (19 in) equipment practice [based on IEEE P1101.1 (D1.0, 1997), 1 IEEE Std 1101.10-1996, IEC 60297-3 (1984-01) [B4]2, and IEC 60297-4 (1995-03) [B5]] for mounting in equipment in according to ANSI/EIA 310-D-1992 [B1] and IEC 60297-1 (1986-01) [B3] (see Figure 1). Standard covers subracks equipped with front mounted plug-in units in accordance with IEEE P1101.1 (D1.0, 1997) and IEEE Std 1101.10-1996, also provides for additional rear mounted plug-in units in the same subrack. Standard allows other suitable IEC connector-related dimensions to be added (see Annex A).
Published | |
Document Type | Standard |
Status | Current |
Publisher | Institute of Electrical & Electronics Engineers |
Pages | |
ISBN | |
Supersedes |
|