Table of Contents

Foreword
Introduction
1 Scope
2 Normative references
3 Terms and definitions
4 Abbreviated terms
5 General recommendations and requirements
6 Qualification dossier
7 Layer test requirements
8 Insulation system test requirements
9 Application process and quality control
10 Requirements for field joints
11 Handling, storage and transportation requirements
Annex A (normative) - Hydrostatic compressive behaviour/
        Tri-axial test procedures
Annex B (normative) - Simulated bend test
Annex C (normative) - Cyclic (fatigue) bend test
Annex D (normative) - Simulated tensioner test
Annex E (normative) - Simulated impact test
Annex F (normative) - Simulated service test (factory applied
        coating)
Annex G (normative) - Simulated service test (field joint)
Annex H (informative) - Simulated service test (subsea equipment)
Annex I (normative) - Ring shear test procedure
Annex J (normative) - Determination of mass ratio of glass
        microspheres, density of glass microspheres after
        processing and entrapped air ratio for glass
        syntactic materials
Annex K (informative) - End of life through thickness
        water profile calculation
Bibliography

Abstract

Describes the minimum requirements for qualification, application, testing, handling, storage and transportation of new and existing wet thermal insulation systems for pipelines, flowlines, equipment and subsea structures in the petroleum and natural gas industries.

General Product Information

Published
Document Type	Standard
Status	Current
Publisher	International Organization for Standardization
Pages
ISBN
Committee	TC 67
Supersedes	ISO/DIS 12736 : 60.00 (2014)