M00024181
New product
METALLIC MATERIALS - SHEET AND STRIP - METHOD FOR SPRINGBACK EVALUATION IN STRETCH BENDING
International Organization for Standardization
In stock
Warning: Last items in stock!
Availability date: 11/05/2021
Foreword
Introduction
1 Scope
2 Normative references
3 Terms and definitions
4 Symbols and designations
5 Principle
6 Test apparatus
7 Test piece
8 Procedure
9 Test report
Annex A (normative) - Method for calculating blank
holding pressure
Annex B (normative) - Method for calculating nominal
tensile stress
Annex C (normative) - Device for determining radius
of curvature using a dial gauge
Bibliography
Describes a method for evaluating the amount of springback of sheets of metallic materials known to exhibit large amounts of springback subjected to plane-strain stretch bending, which is a typical deformation mode generated in press-formed panels.
Published | |
Document Type | Standard |
Status | Current |
Publisher | International Organization for Standardization |
Pages | |
ISBN | |
Committee | TC 164 |
Supersedes |
|