Table of Contents

Foreword
Introduction
1 Scope
2 Normative references
3 Terms and definitions
4 Information required prior to testing
5 Personnel
6 Test equipment
7 Range setting for compression waves
8 Sensitivity setting
9 Test procedure and ultrasonic techniques
10 Classification and sizing of indications
11 Testing of welds
12 Test report
Annex A (informative) - Compression wave angle-beam
        techniques
Annex B (informative) - Stainless steel calibration blocks
        for range setting
Annex C (informative) - Reference blocks for sensitivity
        setting
Bibliography

Abstract

Describes the approach to be followed when developing procedures for the ultrasonic testing of the following welds: - welds in stainless steels; - welds in nickel-based alloys; - welds in duplex steels; - dissimilar metal welds; - austenitic welds.

General Product Information

Published
Document Type	Standard
Status	Current
Publisher	International Organization for Standardization
Pages
ISBN
Committee	TC 44
Supersedes	ISO 22825 : 2012 ISO/DIS 22825 : 60.00 (2017)