Table of Contents

Foreword
Introduction
1 Scope
2 Normative references
3 Terms and definitions
4 Classification of oil burners
5 Constructional and operational requirement
6 Test methods
7 Conformity evaluation
8 Marking, labelling and packaging
Annex A (normative) - Smoke number
Annex B (normative) - Emission measurements and corrections
Annex C (informative) - Conversion factors
Annex D (normative) - FID measuring method for recording
        the unburnt hydrocarbons
Annex E (informative) - Conformity evaluation
Annex F (informative) - Examples of equipping of burners
Annex G (informative) - Additional recommendations for
        specific applications
Annex H (informative) - Air-proving device check
Annex I (normative) - Regional requirements specific to
        European countries
Annex J (normative) - Requirements specific to Japan
Annex K (normative) - Requirements specific to Australia
Annex L (normative) - Requirements specific to Korea
Annex M (normative) - Requirements specific to the USA
Annex N (informative) - Electrical interfaces for burners
Bibliography

Abstract

Describes the terminology, test procedures and general requirements for the construction and operation of automatic forced draught oil burners supplied with a fuel having a viscosity at the burner inlet of 1,6 mm[2]/s (cSt) to 6 mm[2]/s (cSt) at 20 degree C or higher, boiling petroleum in accordance with ISO 8217-based first raffinates, and the provision of related control and safety devices.

General Product Information

Published
Document Type	Standard
Status	Current
Publisher	International Organization for Standardization
Pages
ISBN
Committee	TC 109
Supersedes	ISO/DIS 22968 : 60.00 (2010)