Table of Contents

Foreword
Introduction
1 Scope
2 Normative references
3 Terms and definitions
4 Symbols and abbreviated terms
5 Functional specification
  5.1 General
  5.2 Functional characteristics
  5.3 Well parameters
  5.4 Operational parameters
  5.5 Environmental service grades (class designation)
  5.6 Design validation grades
  5.7 Product functional testing grades
  5.8 Quality grades
  5.9 Additional testing
6 Technical specification
  6.1 General requirements
  6.2 Technical requirements
  6.3 Design criteria
  6.4 Allowable design changes
  6.5 Design verification and validation requirements
  6.6 Product functional testing requirements
7 Supplier/manufacturer requirements
  7.1 General
  7.2 Documentation and data control
  7.3 Product identification requirements
  7.4 Quality control requirements
  7.5 Heat treatment requirements
  7.6 Welding requirements
  7.7 Non-destructive examination (NDE) requirements
  7.8 Storage and shipping preparation
  7.9 Allowable changes after manufacturing
  7.10 Reconditioning and repair of used running,
       pulling and kick-over tools and latches
Annex A (normative) Requirements for running and
        pulling tools
Annex B (normative) Requirements for kick-over tools
Annex C (normative) Requirements for latches
Annex D (normative) Side-pocket mandrel tool interface
        evaluations
Annex E (informative) Figures
Bibliography

Abstract

Gives requirements and guidelines for running tools, pulling tools, kick-over tools and latches used for the installation and retrieval of flow control and other devices to be installed in side-pocket mandrels for use in the petroleum and natural gas industries.

General Product Information

Published
Document Type	Standard
Status	Current
Publisher	International Organization for Standardization
Pages
ISBN
Committee	TC 67
Supersedes	ISO/DIS 17078-3 : 60.00 (2009)