Table of Contents

Foreword
1 Scope
2 Normative references
3 Terms and definitions
4 Symbols and units
5 Purpose of checking
6 Checking methods
  6.1 Measuring principle
  6.2 Line measurement around the circumference
  6.3 Line measurement in the axial direction
  6.4 Point measurement
  6.5 Grading of bearings
  6.6 Eccentric bore
7 Requirements for measuring equipment and specimen for
  the contact method
  7.1 Radius for measuring the outside surface
  7.2 Radius for measuring the inside surface
  7.3 Measuring pin load
  7.4 Set-up
  7.5 Periodic checking
  7.6 Failures on the inside and/or outside surface
8 Checking of measuring equipment
Bibliography

Abstract

Describes the checking of the wall-thickness of thin-walled half bearings with or without flange and describes the required checking methods and measuring equipment.

General Product Information

Published
Document Type	Standard
Status	Current
Publisher	International Organization for Standardization
Pages
ISBN
Committee	TC 123