M00029171
New product
ROTARY SHAFT LIP-TYPE SEALS INCORPORATING ELASTOMERIC SEALING ELEMENTS - PART 4: PERFORMANCE TEST PROCEDURES
International Organization for Standardization
In stock
Warning: Last items in stock!
Availability date: 11/05/2021
Foreword
Introduction
1 Scope
2 Normative references
3 Terms, definitions and symbols
3.1 Terms and definitions
3.2 Symbols
4 Pre-test procedure
5 Dynamic normal-temperature test
5.1 Test apparatus
5.2 Installation
5.3 Test conditions
5.4 Test procedure
5.5 Post-test measurements
5.6 Recording
5.7 Acceptance criteria
6 Dynamic low-temperature test
6.1 General
6.2 Test apparatus
6.3 Installation
6.4 Test procedure
6.5 Post-test measurements
6.6 Recording
6.7 Acceptance criteria
7 Material testing of elastomeric components
7.1 Elastomeric material requirements
7.2 Density
7.3 Hardness
7.4 Compression set
7.5 Fluid immersion
7.6 Dry-heat ageing in air
7.7 Stiffness at low temperature
7.8 Recording
8 Identification statement (Reference to this part of
ISO 6194)
Annex A (informative) - Typical example of a seal test
report for the dynamic test
Annex B (informative) - Typical example of a seal test
report for the dynamic low-temperature test
Annex C (informative) - Typical example of an elastomeric
material test report
Bibliography
Describes general test requirements for rotary shaft lip-type seals.
Published | |
Document Type | Standard |
Status | Current |
Publisher | International Organization for Standardization |
Pages | |
ISBN | |
Committee | TC 131 |
Supersedes |
|