Table of Contents

Introduction
1 General
1.1 Scope
1.2 Classification of electronic equipment
2 Normative references
3 Definitions
4 Normal service conditions
4.1 Altitude
4.2 Ambient temperature
4.3 Vibration and shock
4.4 Relative humidity
4.5 Special service conditions
4.6 Source of power
4.6.1 Supply from an accumulator battery
4.6.2 Supply from a transformer
4.6.3 Waveform of alternating voltage
4.6.4 Supply from a potentiometer device linked
to the contact system
4.6.5 Supply by a rotating set or static convertor
4.6.6 Permitted transient surge voltage
4.7 Common conditions for test place
4.8 Installation
4.9 Protection against short circuits
5 Categories of tests
5.1 Categories of tests
5.2 Type tests
5.3 Routine tests
5.4 Investigation tests
6 Tests
6.1 Test items
6.2 Classification of temperature tests
7 Test methods
7.1 Performance test
7.2 Insulation resistance test
7.3 Dielectric withstand voltage test
7.4 Surge test
7.5 Noise test
7.6 Temperature rise tests
7.7 Cooling test
7.8 Dry heat test
7.9 Damp, heat test
7.10 Cyclic change of temperature test
7.11 Vibration test
7.11.1 Determination of resonant frequencies
7.11.2 Test with sustained vibrations
7.12 Shock test
7.13 Watertightness test
7.14 Dust-proof test
7.15 Continuously passing current test
7.16 Test in corrosive atmosphere
8 Tests and acceptance inspection on complete vehicle
8.1 Performance test
8.2 Protection against surges

Abstract

Applicable to any electronic equipment for control, regulation, protection, supply, etc., installed on rail vehicles.

General Product Information

Published
Document Type	Standard
Status	Current
Publisher	Japanese Standards Association
Pages
ISBN
Supersedes	JIS E 5006:2005