Table of Contents

Introduction
1 Scope
2 Normative references
3 Terms and definitions
4 General requirements
4.1 Representative testing
4.2 Identification marks of samples, rough specimens and
test pieces
5 Preparation of samples and selection of test pieces
5.1 Location of samples and test pieces and dimensions
of samples
5.2 Direction of axis of test pieces
5.3 Condition and selection method of samples
6 Preparation of test pieces
6.1 Cutting and machining
6.2 Reference heat treatment
Annex A (normative) Location of samples and test pieces
Annex JA (informative) Comparison table between JIS and
corresponding International Standard

Abstract

Specifies identification marks, location and preparation of samples and test pieces intended for mechanical tests taken from steel sections, bars, rods, sheets and tubular products.

General Product Information

Published
Document Type	Standard
Status	Current
Publisher	Japanese Standards Association
Pages
ISBN
Supersedes	JIS G 0416:2006