Table of Contents

Introduction
Section One - General
1 General
1.1 Scope
1.2 Object
1.3 Normative references
1.4 Information to be given in a detail specification
1.5 Terminology
1.6 Marking
Section Two - Preferred ratings and characteristics
2 Preferred ratings and characteristics
2.1 Preferred characteristics
2.2 Preferred values of ratings
Section Three - Quality assessment procedures
3 Quality assessment procedures
3.1 Primary stage of manufacture
3.2 Structurally similar components
3.3 Certified records of released lots
3.4 Qualification approval
3.5 Quality conformance inspection
Section Four - Test and measurement procedures
4 Test and measurement procedures
4.1 Visual examination and check of dimensions
4.2 Electrical tests
4.3 Robustness of terminations
4.4 Resistance to soldering heat
4.5 Solderability
4.6 Rapid change of temperature
4.7 Vibration
4.8 Bump
4.9 Shock
4.10 Climatic sequence
4.11 Damp heat steady state
4.12 Endurance
4.13 Component solvent resistance
4.14 Solvent resistance of the marking
Related standards

Abstract

A sectional specification in association with the generic specification JIS C 5101-1, applicable to fixed direct current capacitors, for rated voltages not greater than 6 300 V, with the use of dielectric a polyethylene-terephthalate film and electrodes of thin metal foils. Additional test and requirements may be specified in the detail specification for capacitors with a rated voltage exceeding 1 000 V.

General Product Information

Published
Document Type	Standard
Status	Current
Publisher	Japanese Standards Association
ProductNote	Supersedes JIS C5113 (06/2002) Supersedes JIS C5101 and JIS C5111 (07/2002)
Pages
ISBN
Supersedes	JIS C 5101:1995 JIS C 5101-11:1998 JIS C 5113:1991 JIS C 5111:1995