Table of Contents

1. SCOPE
2. APPLICABLE DOCUMENTS
3. TECHNICAL REQUIREMENTS
4. QUALITY ASSURANCE PROVISIONS
5. PREPARATION OF DELIVERY
6. ACKNOWLEDGMENT
7. REJECTIONS
8. NOTES
APPENDIX A - MEASUREMENT OF PERPENDICULARITY
             VARIATION OF THE BEARING SURFACE
APPENDIX B - WRENCH TORQUE TEST
APPENDIX C - PUSH OUT TEST
APPENDIX D - TORQUE OUT TEST
APPENDIX E - PERMANENT SET TEST
APPENDIX F - REUSABILITY TEST AT ROOM TEMPERATURE,
             AFTER BAKING
APPENDIX G - REUSABILITY TEST AT ROOM TEMPERATURE,
             AS RECEIVED CONDITION
APPENDIX H - THREE CYCLES TEST AT ROOM TEMPERATURE
APPENDIX J - ACCEPTANCE CRITERIA OF SURFACE
             DISCONTINUITIES ON SELF LOCKING NUTS

Abstract

Specifies the requirements for the following types of self locking nuts: wrenching nuts, i.e., hex, double hex, spline drive; and anchor nuts, i.e., plate nuts, gang channel nuts, shank (clinch) nuts.

General Product Information

Published
Document Type	Standard
Status	Current
Publisher	SAE International
Pages
ISBN
Committee	E-25